Sound Forge iZotope 64-Bit SRC

Данная статья является частью цикла статей "Sound Forge"

Необходимо перевести статью или её часть.

Вы можете помочь улучшить эту статью, переведя её на русский язык.

Технология iZotope 64-bit SRC использует гибридный низкочастотный фильтр, обеспечивая полное сохранение качества при переводе цифрового звука из одной частоты дискретизации в другую.

  1. Newsample rate - определяет новую частоту сэмплирования (дискретизации);
  2. Use simplified Quality setting - включение упрощённой настройка качества обработки Quality (качество). Чем выше качество тем дольше обработка файла. В большинстве случаев хорошо работает значение 50%;
  3. Steepness (крутизна) - The plug in uses a low-pass filter to discard frequencies that cannot be represented or are undesirable in your audio output. Этот параметр определяет крутизну переходной полосы фильтра низких частот. Higher settings will reject unwanted frequencies, but can cause more ringing in the time domain and a higher CPU load;
  4. Max filter length - устанавливает максимальную длину фильтров, используемых для передискретизации. Значение по умолчанию хорошо работает для большинства данных, но вы можете увеличить этот параметр, if very high-quality output is desired for uncommon source or destination sampling rates;
  5. Cutoff scaling - Allows you to scale the cutoff frequency of the plug-in's low-pass filter from the Nyquist frequency. Typical values are near 1. Higher values will offer a flatter pass-band, and lower values will offer better aliasing suppression;
  6. Alias suppression - Sets the amount of suppression in the low-pass filter's stop-band. Frequencies in the stop-band that are not fully attenuated will result in aliasing. Higher settings will result in better quality, and lower settings can minimize CPU load;
  7. Prering - Low-pass filters are characterized by the amount of ringing they introduce into their output. Higher Steepness settings produce increased ringing. Настройка 100% производит линейно фазовую фильтрацию. A setting of 0% produces a minimum phase filter that offers no preringing but has nonlinear phase distortion. Intermediate settings allow a tradeoff between preringing and postringing and allows you to linearize phase in the pass-band;
  8. Set the sample rate only (do not resample) - Установите этот флажок, чтобы изменить соотношение без превдения передискретизация данных. Это означает, что первоначальный Питч файл не сохраняется;