Правка может быть отменена. Пожалуйста, просмотрите сравнение версий ниже, чтобы убедиться, что это нужная вам правка, и запишите страницу ниже, чтобы отменить правку.
Текущая версия | Ваш текст | ||
Строка 167: | Строка 167: | ||
==== Reverse ==== | ==== Reverse ==== | ||
The Reverse reverb algorithm in RV7000 is special in that it actually "moves" the source audio as well. Sounds fed into the Reverse reverb are "sampled", a reverse reverb is created and played back and finally the "sampled" original sound is played back. For example, if you feed a snare drum hit into the Reverse reverb, you will hear a rising "backwards" reverb, followed by the snare drum hit. | |||
Therefore, you probably don't want to hear the first, original (dry) sound. There are two ways to set this up: | |||
* | *Connect the RV7000 as an insert effect and make sure the Dry/Wet control on the main panel is set fully to "Wet". | ||
*Connect the RV7000 as a send effect using send 4 on the Mixer, activate the Prefader (P) switch for the send and lower the mixer fader completely for the source signal. That way, the signal will be sent to the reverb but the dry sound from the Mixer channel isn't heard. Again, the Dry/Wet control should be set to "Wet". | *Connect the RV7000 as a send effect using send 4 on the Mixer, activate the Prefader (P) switch for the send and lower the mixer fader completely for the source signal. That way, the signal will be sent to the reverb but the dry sound from the Mixer channel isn't heard. Again, the Dry/Wet control should be set to "Wet". | ||
Note that with this algorithm, raising the Decay setting on the main panel will make the reverse reverb start earlier and build up under a longer time. Similarly, the HF Damp parameter affects how fast the high frequencies are built up in the reverse reverb. In the remote panel, the Reverse algorithm has the following parameters: | |||
#'''Length''' - установка времени момента, когда источник сигнала подается в ревербератор, пока он не играл реверсированно. Именно в это время вы будете слышать реверсированную реверберацию, как показано на дисплее. Можно установить время в миллисекундах или как значения, в зависимости от того, выключен '''Tempo Sync''' или нет. | #'''Length''' - установка времени момента, когда источник сигнала подается в ревербератор, пока он не играл реверсированно. Именно в это время вы будете слышать реверсированную реверберацию, как показано на дисплее. Можно установить время в миллисекундах или как значения, в зависимости от того, выключен '''Tempo Sync''' или нет. |